Gbc Stl1000 Bedienungsanleitung PDF herunterladen (Seite 37)

36

Pushers won’t advance

when foot switch is

depressed. (continued)

LS1 home switch. Remove center panel on the

tabletop (section 18 drawing 2

detail #23). Located LS1 on the

left side of the air cylinder

Loosen the clamp, which

secures LS1 to the air cylinder.

Slide LS1 to the left or right until

the LED on LS1 illuminates.

Tighten clamp to secure to air

cylinder. Depress foot switch

and test for a completed cycle.

Replace tabletop.

Pushers advance then

stop.

LS2 needs to be adjusted. Remove center panel on

tabletop (section 18 drawing 2

of 3 detail #23). Locate LS2 on

the right side of the air cylinder).

Loosen the clamp, which

secures LS2 to the air cylinder.

Close safety hood, turn power

on, press pusher advance key on

the keypad. This will advance

the pushers to the right. Slide

LS2 to the right or left until the

LED on LS2 illuminates.

Tighten clamp to secure LS2 to

the air cylinder. Depress pusher

key to return the pushers to their

home position. Depress foot

switch and test for a complete

cycle. Replace tabletop.

Pushers advance, safety

doors close, cycle stops.

Door switch IS2. Check closing doors for any

obstruction.

PROBLEM PROBABLE CAUSE SOLUTION

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43

Kommentare zu diesen Handbüchern

Keine Kommentare